IBM IntelliStation E Pro 6836, User Manual

Page: 70 / 156

v
If the drive is a SCSI device, plug one connector of the SCSI signal cable
into the back of the drive and the other end of the cable into the SCSI
adapter. See “Installing a SCSI adapter (some models)” on page 49 for
details.
Note: Make sure to route the signal cable so that it does not block the air
flow to the rear of the drives or over the microprocessor.
10. Plug one of the power cables from the power supply into the back of the
drive. The connectors are keyed and can be inserted only one way.
11. If you have other options to install or remove, do so now.
12. Replace the support bracket assembly and reconnect the fan cable to the
connector (SYSFA3) on the system board. See “Removing the support bracket
assembly” on page 46 for installation instructions.
13.
Reinstall the side cover. See “Installing the cover” on page 58 for details.
14. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Installing a hard disk drive in bay 5, 6, or 7
Complete the following steps to install a hard disk drive in bay 5, 6, or 7.
Drive cage release tab
Drive cage retention tab
Attention: When you handle ESD-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 38.
1.
Review the safety precautions listed in “Safety information” on page 39.
2. Remove any media (diskettes, CDs, or tapes) from the drives and shut down
your operating system.
3.
Turn off the computer and attached devices and disconnect all external cables
and power cords; then, remove the cover. See “Removing the side cover” on
page 45 for details.
54
IBM
®
IntelliStation
®
E Pro: User’s Guide IntelliStation E Pro Types 6836, 6846