IBM FlashSystem 900, Installation And Maintenance Manual

Page: 205 / 390

Server 111.11.11.10
Gateway 111.11.11.10
Subnet mask 255.255.255.0
3
The Ping option allows you to test connectivity.
Change Management
Change Management enables you to manipulate the multiaccess enclosure level of
software code that will run on the multiaccess enclosure (Appendix E, “Managing
Operational Code and Configuration Files” on page E-1 has additional information
about change management.
Xmodem Software Selection
The Xmodem protocol is supported only from the “System Management Services”
menu. To access the “System Management Services” menu, you have to either
interrupt the boot-up sequence or bring up the multiaccess enclosure in Attended
mode. The Change Management command is available from the “System
Management Utilities” option of the Main Menu. From that point, the multiaccess
enclosure will direct you as to what to transfer in and where to put the image.
Note: When the multiaccess enclosure is in firmware mode, there is no active
configuration or image. Therefore, you should use caution when specifying where
to write new images or configurations.
Chapter 5. Multiaccess Enclosure Firmware and Operational Code
5-29