IBM FlashSystem 840, Installation Manual

Page: 36 / 78

9. On the front of the rail, press the two bracket pins into the holes in the rack
flanges and close the front hinge bracket to secure the rail to the rack cabinet
flange (see Figure 5).
10. Secure the rear of the rail to the rear rack flange by installing an M5 screw
between the upper and lower mounting pins (see Figure 5).
11. Repeat steps 7 on page 13 through 10 to secure the opposite rail to the rack
cabinet.
Installing the enclosure
Following your location plan, install the enclosure in the rack.
Before you begin
CAUTION:
To avoid any hazard from the rack tipping forward when devices are installed,
observe all safety precautions for the rack into which you are installing the
device.
Figure 5. Closing hinge brackets and installing rear screw
14
FlashSystem 840: Installation Guide