IBM FlashSystem 840, Installation Manual

Page: 34 / 78

1
Upper rail mounting bracket pin
2
Rack mounting screw hole
3
Lower rail mounting bracket pin
Note: Each rail comes with two medium bracket pins in the front bracket and
two medium bracket pins in the rear bracket. The medium bracket pins are for
installation in a 19-inch IBM rack cabinet. If you are installing the enclosure in
a non-IBM rack cabinet, you might need to replace the set of medium bracket
pins on the front and rear of the rail with either the small or large bracket
pins that are included in the rail kit.
6. At each end of the rail, grasp the tab
1
and pull firmly to open the hinge
bracket (see Figure 4 on page 13).
Figure 3. Hole locations in the front of the rack
12
FlashSystem 840: Installation Guide