Chapter 5. Installing options
41
static-protective bag. (If your device is an adapter, place it component side up.)
Do not place the device on your system unit cover or on a metal table.
•
Take additional care when handling devices during cold weather because heating
reduces indoor humidity and increases static electricity.
Removing the server top cover and bezel
Review the information in “Before you begin” on page 39.
To remove the server top cover and bezel:
1.
Lift the plastic cover-release latch near the edge of the top cover.
2.
Slide the top cover slightly toward the rear of the server; the cover will stop after
moving approximately 25 mm (1 inch). Lift the cover off the server, and set the
cover aside.
Attention:
For proper cooling and airflow, replace the top cover before turning
on the server. Operating the server for extended periods of time (over 30 minutes)
with the top cover removed might damage server components.
3.
Release the two tabs at the top edge of the bezel, and pull the top of the bezel
slightly away from the server.
4.
Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store the
bezel in a safe place.
Top cover
Release latch
Release latch
Cover release latch
Bezel
Summary of Contents for eserver xSeries 350
