IBM eserver xSeries 350, User Reference Manual

Page: 115 / 174

Chapter 6. Solving problems
103
215 CD-ROM Stopped The CD-ROM drive is not present Verify that the cables are
properly connected to the
CD-ROM drive.
If the problem persists,
call for service.
217 Hard disk drive Failed BIOS drive # n (where n is the drive bay number) Call for service.
264 Magnetic tape
drive Stopped Test setup error: No tape drive found Check the cable and
power connections to the
drive.
Refer to the information
that is provided with the
tape drive.
If the problem persists,
call for service.
Failed The load/mount test failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
Refer to the information
provided with the tape
drive.
If the problem persists,
call for service.
Note: The push button
test is applicable
only to SCSI tape
drives that have a
push button.
The Self-diagnostic failed for device n on adapter
m.
(where n is the number of the device and m is the
adapter number)
The unload/eject test failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
The unload/eject push button test failed for
device n on adapter m
(where n is the number of the device and m is the
adapter number)
The Read/Write Self-diagnostic failed for device
n on adapter m
(where n is the number of the device and m is the
adapter number)
Insert a new tape
cartridge; then, run the
diagnostic test again.
Refer to the information
that is provided with the
tape drive.
If the problem persists,
call for service.
301 Keyboard Failed On system board keyboard test failed 1. Verify that the
keyboard cable is
connected.
2. If the problem
persists, replace the
keyboard cable.
If the problem persists,
call for service.
Code Function Result Text message Action