IBM eserver xSeries 350, User Reference Manual

Page: 103 / 174

Chapter 6. Solving problems
91
8603 An error occurred during the mouse (pointing device) controller test. The addition or removal of
a mouse, or a failing system board can cause this error.
Note: This error also can occur if electrical power was lost for a very brief period and then
restored. In this case, turn off the server for at least 5 seconds; then, turn it back on.
Action: Ensure that the keyboard and mouse (pointing device) are attached to the correct
connectors. If they are connected correctly, use the following procedure:
1. Turn off the server.
2. Disconnect the mouse from the server.
3. Turn on the server.
If the POST error message does not reappear, the mouse is probably failing. See the
documentation that comes with the mouse for additional testing information. If the problem
remains, replace the mouse or pointing device.
If the POST error message reappears, run the diagnostic tests to isolate the problem. If the
diagnostic tests do not find a problem and the POST error message remains, call for service.
00012000 Processor machine check.
Action: 1. Update the system BIOS.
2. If the problem persists, replace the microprocessor.
00019501 Processor 1 is not functioning.
Action: Replace microprocessor 1.
(The microprocessor 1 error light will be on.)
If the problem persists, call for service.
00019502 Processor 2 is not functioning.
Action: Replace microprocessor 2.
(The microprocessor 2 error light will be on.)
If the problem persists, call for service.
00019701 Processor 1 failed the built-in self test.
Action: Replace microprocessor 1.
(The microprocessor 1 error light will be on.)
If the problem persists, call for service.
00019702 Processor 2 failed the built-in self-test.
Action: Replace microprocessor 2.
(The microprocessor 2 error light will be on.)
If the problem persists, call for service.
00180100 A PCI adapter has requested memory resources that are not available.
Action: 1. Make sure that the PCI adapter and all other adapters are set correctly in the
Configuration/Setup Utility program. If the memory resource settings are not
correct, change the settings.
2. If all memory resources are being used, you might need to remove an adapter to
make memory available to the PCI adapter. Disabling the adapter BIOS on the
adapter might correct the error. Refer to the documentation that comes with the
adapter.
Table 16. POST error messages.
POST message Description