IBM DDRS-39130 - Ultrastar 9.1 GB Hard Drive, Specifications

Page: 187 / 228

9.4.6 INITIATOR DETECTED ERROR Message
An I N I T I A T O R D E T E C T E D E R R O R message is valid after a C O M M A N D , D A T A I N / O U T or
STATUS phase has occurred. If another phase has occurred, the message is rejected.
The file will, depending on the model, optionally retry the previous phase is it is command or status. If this
fails or the previous phase was a data transfer the file will generate a C H E C K C O N D I T I O N status and a
Sense key of A B O R T E D C O M M A N D with additional sense code of I N I T I A T O R D E T E C T E D E R R O R .
9.4.7 MESSAGE REJECT Message
The file will take the following actions after receiving the MESSAGE R E J E C T message in response to mes-
sages listed below.
DISCONNECT The file will not disconnect but remains connected.
COMMAND COMPLETE N o error, continue to bus free.
IDENTIFY Command aborted - bus freed - Sense data set to MESSAGE R E J E C T E R R O R .
LINKED CMD CMPLT Command aborted - link broken - bus freed - sense data set to MESSAGE
R E J E C T E R R O R .
MESSAGE REJECT Command aborted - STATUS phase executed with C H E C K C O N D I T I O N - sense
data set to MESSAGE R E J E C T E R R O R .
RESTORE POINTERS Command aborted - status set to C H E C K C O N D I T I O N - sense will be set with
the error that caused the R E S T O R E P O I N T E R S message to be issued. (Assuming
that error recovery is in progress)
SAVE DATA POINTER The file will not disconnect from the SCSI bus. It will not be considered an error.
No previous Msg The command is aborted, the bus freed, and Sense data is set to MESSAGE
R E J E C T E R R O R . This occurs when the file has not sent a message, but gets a
MESSAGE R E J E C T from the initiator.
SCSI MESSAGE SYSTEM
177