IBM Cloud Object Storage System Slicestor 2212..., Service And Maintenance Manual

Page: 165 / 197

Note: The
Config only
>
prompt appears when no config file is active. Lack of an active
config file indicates that an active configuration has become corrupted or that the
IBM 2212 is not configured.
¹
From the Bootstrap Menus, choose the
issue reset
option. The issue reset option on the
Bootstrap Menus causes the IBM 2212 to behave as if it has been powered off and back
on: system card and hard drive or compact flash component tests are run and the
operational code is reloaded. See Chapter 4, “Using the IBM 2212 Bootstrap Menus” on
page 4-1.
¹
At the
SVC>
prompt, type reboot and press Enter. This causes the IBM 2212 to test the
system card and hard drive or compact flash components and reload the operational
software on the hard drive or compact flash.
Note: The software that is loaded and interface the IBM 2212 boots to are determined by the
current boot mode setting. To change the boot mode setting, access the
SVC>
prompt
and use the bootmode command. (See“Accessing the Service Recovery Prompt
(SVC>)” on page E-4.)
Running Quick Configuration
Question How do I run the Quick Configuration program?
Answer First, make sure each adapter has been added. See “Adding an Adapter at Initial
Configuration” on page E-6. Then, at the
Config (only)
or
Config
>
prompt, enter qc.
Viewing Hardware and Software Vital Product Data
Question How do I view vital product data (VPD)?
Answer
1. Access the OPCON ( * ) prompt. (See “Accessing the OPCON Command Line Interface” on
page E-2.)
2. At the OPCON prompt, type talk 6 and press Enter.
3. Type list vpd and press Enter to view the IBM 2212 hardware and software VPD.
Appendix E. Common Tasks
E-27