IBM BNT RackSwitch G8124, Installation Manual

Page: 43 / 88

5. Use the M6 washers, screws, and clip nuts to attach the filler plate to the rear
mounting brackets. Torque the screws to approximately 5.7 Nm +/- 0.1 Nm (50
inch-pounds).
4
2
6
8
6. Use the M3.5 screws to secure the rear brackets to the front brackets. Torque
the screws to approximately 2.0 Nm +/- 0.1 Nm (17.7 inch-pounds).
9
10 11
3
7. Connect all the cables.
8. Initialize the switch, see Chapter 4, “Initializing the RackSwitch,” on page 43.
Attention: If this is a switch replacement, make sure that the vital product
data (VPD) is updated to avoid losing the licensed electronic entitlement data of
the RackSwitch. For more information, see “Configuring Vital Product Data after
a switch replacement” on page 41.
Chapter 2. Installing the RackSwitch and options
27