IBM BNT RackSwitch G8124, Installation Manual

Page: 29 / 88

Chapter 2. Installing the RackSwitch and options
This chapter describes the how to install the RackSwitch chassis and the
associated RackSwitch components.
v “Installing the RackSwitch in a standard equipment rack” on page 18
v
“Installing the RackSwitch in an IBM iDataPlex rack” on page 21
v “Installing the RackSwitch in an IBM System x or Power rack” on page 24
v
“Installing the 1U air duct option” on page 28
v “Installing an SFP or SFP+ transceiver” on page 32
Note: When replacing a RackSwitch chassis, all internal components must also be
removed from the chassis and replaced in the new chassis. For more
information on removing and replacing the RackSwitch and components, see
Chapter 3, “Removing and replacing the RackSwitch and components,” on
page 35.
Before installing the RackSwitch
Locate and record the important product information about the switch in the
following table. The identification labels contain the machine-type model (MTM)
number, serial number and part number (front, rear panel and/or bottom of the unit),
and the media access control (MAC) address (rear of unit) for the switch. The MAC
address is not required for opening a service call.
You can also review and record your product serial number and other required
information through the software interface by issuing the show
sys-info
command
using the ISCLI interface or the
/info/sys/general
command using the MenuCLI
interface. For more information about these commands, see “Configuring Vital
Product Data after a switch replacement” on page 41.
After the switch is installed most of the identification labels are hidden from view
and require removing the switch in order to relocate them.
Attention: This product information is required to register your product, to update
your firmware, place a service call, and replace the RackSwitch.
Note: The following sample RackSwitch identification (ID) labels may have different
MTM and part numbers than your unit.
© Copyright IBM Corp. 2013
13