IBM BladeCenter Management Module, Installation And User Manual

Page: 70 / 184

This window enables you to configure traffic class priority by specifying the class
value, from
Low Priority to High Priority , of the switch eight levels of priority. Click
Apply to make your changes effective.
This window enables you to set the following features:
To set up DiffServ Mapping, select Enabled in the first drop-down menu on the
preceding window, enter a beginning and ending Code Point (0 to 63) in the second
field, and select the desired Class in the next field (
Low Priority , Med-L Priority ,
Med-H Priority , or High Priority ). When you are finished, click Apply to make your
changes effective.
Link Aggregation
The switch module supports Link Aggregation, or port trunking. Port trunks
(aggregated ports) can be used to increase the bandwidth of a network connection
or to ensure fault recovery.
You can configure up to two trunk connections (combining two to four ports into one
fat pipe) between any two BladeCenter switches or other Layer 2 switches.
However, before making any physical connections between devices, use the Link
Aggregation menus to specify the ports that will belong to the trunking group on
both switches.
52
IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation and User’s Guide