IBM Aptiva 2161, Manual

Page: 123 / 222

5. If a critical error is encountered, the system halts.
6. The system attempts to load the operating system as customized. If an
operating system is not found, a graphic message (icon) is displayed
requesting the user to insert a diskette into drive A and press the F1 key
to resume operation.
Diagnostics and Utilities CD
The Diagnostics and Utilities program comes on a CD packaged with this
book. The CD is labeled “Diagnostics and Utilities CD.”
The QAPlus/PRO diagnostic programs, developed by DiagSoft for IBM, are
the primary method of testing the computer. You can use them to test the
IBM components of the system and some external devices. The amount of
time required to test all components depends on the number of components.
The more optional adapters and devices you have attached to your system,
the longer the testing takes.
The Diagnostics and Utilities program is intended to test only IBM products.
Non-IBM products, prototype cards, or modified options can give false errors
and invalid system responses.
To load the Diagnostics and Utilities CD:
Note: Before beginning, ensure that Rapid Resume is disabled in the Setup
Utility.
1. Install the Diagnostics and Utilities CD in the CD-ROM drive.
2. Power-off, then power-on the system unit.
3. Do not press F1 during POST.
4. If any POST errors appear after POST, make a note of the errors and
press the Esc key.
5. Select an option on the “Aptiva Diagnostics and Utilities Menu.”
6. Follow the instructions that appear on your screen. If an error occurs,
go to “Index of Symptoms, Messages, Error Codes, or Beeps” on
page 2-9.
Note:
This Service Level A Diagnostics will not support Low Level format.
When performing hard disk diagnostics, the system may go into Standby
mode. Depression of any key will bring the system out of standby
mode.
Diagnostic Aids
3-3