IBM Aptiva 2161, Manual

Page: 107 / 222

019 (continued)
– Power-off the system unit.
– Reinstall the sound adapter card or adapter card and any cables.
– Power-on the system unit without the Diagnostics and Utilities CD
inserted.
Note: This procedure can be used for most factory-installed adapter
cards. However, you must select the correct window (see steps 3
and 4 below) to access the feature icon before any test or before
testing any feature in step 6.
– Perform the following when the system is running:
Note: If an operating system other than Microsoft Windows 95 is
installed, program screens and icons might differ from these
instructions.
1. Open Microsoft Windows 95 if not already opened by the system.
2. Select the Start icon.
3. Select Settings, then select Control Panel.
4. Select the Sound icon.
5. In the Sound window, select
chimes from the Names field. (To test
other adapter card software, select an action from a menu in that
software.)
IS THE PREVIEW BUTTON (OR ACTION IN OTHER SOFTWARE)
SELECTABLE ON THE SCREEN (SHOWN IN BLACK AND NOT GRAY)?
Yes No
020
– Power-off the system unit.
– Check the sound adapter card for proper installation.
– Replace the sound adapter card.
021
– Select the Preview button from the Sound window.
DO YOU HEAR ANY SOUND FROM THE SYSTEM?
Yes No
022
– Make sure the speaker power cable is plugged into the speaker
power connector in back of the system unit.
– Check for 12 V dc at the speaker power connector. If no voltage,
check speaker power internal cable continuity with power off and
replace if necessary. If voltage not present at the system board
Check Procedures
2-53