IBM Aptiva 2159, Manual

Page: 155 / 214

2060—Processor Removal
Attention: Processors are sensitive to static discharge. See “Handling
ESD-Sensitive Parts” on page 4-18.
Ÿ
Adapter cards (2035) if applicable.
Ÿ
To remove the processor: remove the processor retaining clip, raise the
socket lever, remove the old processor, insert the upgrade processor,
lower the socket lever firmly, then install the processor retaining clip.
Ÿ
When installing, be certain the dot on the processor is aligned with the
dot in the socket.
Notes:
1. Determine which type of processor you are installing and make sure the
jumpers are set correctly.
2. Run the Setup Utility after installing a processor.
processor
socket
processor
notch
heat
sink
retaining clip
3
2
Figure 4-16. Processor removal
Repair Information
4-15