IBM 883725U, Installation Manual

Page: 25 / 114

v
If you are installing a hot-swap drive, continue with “Installing a hot-swap hard
disk drive.” If you are installing a simple swap drive, go to “Installing a simple
swap hard disk drive” on page 14.
Installing a hot-swap hard disk drive
If you are installing a 2.5-inch hot-swap drive, continue with “Installing a 2.5-inch
hot-swap hard disk drive.” If you are installing a 3.5-inch hot-swap drive, go to
“Installing a 3.5-inch hot-swap hard disk drive.”
Installing a 2.5-inch hot-swap hard disk drive
This section provides an overview of the procedure for installing a 2.5-inch
hot-swap hard disk drive. For detailed instructions, see the Option Installation
Guide .
Filler panel
Drive-tray assembly
Drive handle
Complete the following steps to install a 2.5-inch hot-swap SCSI hard disk drive:
1. Read the safety information.
2. Remove the filler panel from the drive bay.
Note: To make sure there is adequate system cooling, do not operate the
server for more than 2 minutes without either a hard disk drive or a filler
panel installed in each bay.
3. Place the drive handle in the open position and slide the drive into the bay.
4. Close the drive handle.
5. If you have other options to install or remove, do so now.
6. Go to “Completing the installation” on page 22.
Installing a 3.5-inch hot-swap hard disk drive
This section provides an overview of the procedure for installing a 3.5-inch
hot-swap hard disk drive. For detailed instructions, see the Option Installation
Guide .
Filler panel
Drive-tray assembly
Drive handle
Chapter 2. Installing options
13