IBM 8364 E series, User Manual, Page: 81 / 150

Chapter 11. Identifying problems with hardware that is
configured for NS Boot
This chapter contains the procedures for identifying hardware problems that
can occur to Network Station hardware that you have configured from the NS
Boot utility. To learn more about selecting a setup utility for Network Station
hardware, refer to “Part 3. Configuring the Network Station” on page 37.
Continue with “Starting point for all problems” to identify Network Station
hardware problems.
Note:
For the Network Station hardware to function properly when connected
to a network server, ensure that you have performed the following
tasks before continuing with the “Starting point for all problems”:
v
Install and configure the appropriate server software on the network
server (go to
http://www.ibm.com/nc
for the latest installation
information).
v
Configure the Network Station hardware for the network server
software (see “Part 3. Configuring the Network Station” on page 37).
You can obtain additional service support information on the World
Wide Web at the following URL:
http://www.ibm.com/nc
In the left frame, click Support.
Starting point for all problems
Network Station hardware reports hardware problems and configuration
errors when detected. The Network Station indicates problems in the
following ways:
v
System LED indications.
v
Audio beep sequences.
v
Error codes and text messages.
LED indications and audio beep sequences generally occur before the IBM
Network Station logo displays. Error messages only appear on the monitor
after the IBM Network Station logo displays. It is important that you record
any system LED indications, audio beep sequences, error codes, or text
messages that occur when you experience a problem.
© Copyright IBM Corp. 1999
69