IBM 8364 E series, User Manual, Page: 36 / 150

Clearing the administrator password and CMOS, creating a recovery
CompactFlash card, and reading a CompactFlash card
Clearing the administrator password, and
CMOS
Network Stations configured for WSOD: This
procedure clears all configuration settings on
Network Stations that have been configured from
the BIOS setup utility for the WorkSpace
On-Demand operating system (hereafter referred
to as WSOD). Refer to “Chapter 7. Selecting a
setup utility” on page 39 when you have
completed this procedure.
Network Stations configured for NS Boot: This
procedure only clears the administrator
password. This procedure does not not load
factory default settings. If you want to load the
factory default settings on a Network Station that
has been configured from the NS Boot utility,
perform the procedure “Loading the factory
defaults” on page 50.
1. Perform the procedure, “Removing the logic
unit to install parts” on page 18 before
continuing.
2.
Move the jumpers into configuration
«2¬
.
Note: All systems ship with jumpers installed
in configuration
«1¬
.
3. Power on the Network Station and wait a few
moments.
This requires you to reconnect the power
cable to the logic unit. The system LED
flashes green at this time, on Network
Stations that are configured for WSOD. There
are no system LED indications at this time,
on Network Stations that are configured for
NS Boot.
4.
Power off the system.
5.
Move the jumpers back into the default
configuration
«1¬
.
If you do not move the jumpers back into
configuration
«1¬
, your Network Station may
not function properly.
6. See “Reassembling the Network Station” on
page 18.
24
IBM Network Station