IBM 8364 E series, User Manual, Page: 119 / 150

Table 10. Configuration errors (continued)
Error code Error message Cause Suggested actions
178X Hard Disk Error Hard disk could
not be configured
or failed Restart the Network Station; or,
replace the logic unit (see
“Replacing the logic unit” on
page 9).
2401 Video Error Video failed to
configure or video
failed test Ensure that the monitor cable is
connected properly to the
Network Station; or, swap
monitors and cables; or, replace
logic unit (see “Replacing the
logic unit” on page 9).
8603, 8601 Pointing Device
Error Mouse test failed Power off the Network Station,
and ensure that the mouse is
installed in the correct port (see
“Hardware layout” on page 4);
or, replace the mouse.
1962 Boot Sequence
Error Boot sequence
failed Restart the Network Station; or,
perform the procedure,
“Clearing CMOS” on page 24.
Note:
Ethernet systems can
receive a beep and a 1962
configuration error if the system
is unable to boot from the
network. Restart the Network
Station, and watch for any error
codes or text messages that
display before the 1962 error
code. Perform any actions
indicated the error codes or text
messages.
18XX PCI
Configuration
Error PCI adapter failed Perform the procedure,
“Clearing CMOS” on page 24;
or, enter the BIOS setup utility
and ensure that you configured
the PCI device correctly. If the
problem continues, replace the
PCI adapter.
Chapter 13. Identifying problems with hardware that is configured for BIOS
107