Removing the Service Access Covers
Service Access Cover (Model 6E1 )
1
CPU
VRM
MEMOR
Y
HDD
PCI B
US
NMI
SMI
SER
VICE PR
OCESSOR
BUS
NON REDUND
ANT
PO
WER SUPPL
Y
1 2 3
A B
1 2 3
FA
N
TEMPERA
TURE
2
1
Cover-release latch
2
Service access cover
1. If you are planning to install or remove any part other than a hot-swap hard disk
drive, hot-swap power supply, or hot-swap fan, turn off the server and all attached
devices and disconnect all external cables and power cords.
2. Slide the cover-release lever (1) to the right to release the cover and slide the cover
(2) toward the rear of the server about 25 mm (1 inch). Move the top edge of the
cover out from the server; then, lift the cover off the server. Set the cover aside.
Attention:
For proper cooling and airflow, replace the cover before turning on the
server. Operating the server for extended periods of time (over 30 minutes) with the
cover removed might damage server components.
Chapter 3. Installing Options in Your System
37
Summary of Contents for 6C1
