IBM 6400i, Setup Manual

Page: 64 / 370

64
Chapter 2
Install The Ribbon
Figure 44. View of the Forms Thickness Lever in the Raised Position
3. Raise the forms thickness lever as far as it will go.
4. Press STOP to silence the alarm.
5. Close the tractor doors.
6. Remove the ribbon spools from the package.
Figure 45. View of the Right Ribbon Hub with Ribbon Spool Above
7. With the ribbon supply to the outside, squeeze the right hub latch and
place the full spool on the right ribbon hub.
8. Press the spool down until the hub latch snaps into place.
NOTE: The ribbon must not be twisted. A twisted ribbon can lower print
quality, shorten ribbon life, and cause paper or ribbon jams.
If you are installing a “Clean Hands” ribbon (identified by a long
metalic leader), the leader will enable you to install the ribbon without
getting ink on your hands.
Tractor Door
Forms Thickness
Lever
Right Hub
Latch
Spool