IBM 4247 A00, User Manual

Page: 123 / 322

2. If Paper Overlay is set to YES, when loading cut-sheet paper into the printer,
hold the paper firmly in place until it is fed into the printer.
To change or check the Paper Overlay value:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer.
3. After start-up is complete, release Menu/Enter and the message
PRINT OUT=NO
displays.
4. Press
↓
until the message
FUNCTIONS
displays.
5. Press
→
until the message
FRONT TEAR=xxxx
displays, where xxxx can be
NORM
,
AUTO
, or
NO
.
6. Press
↓
until the message
PAPER OVERLY=xxx
displays, where xxx can be
NO
or
YES
. If you want to select a value other than the one displayed, press
←
or
→
.
7. To exit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM and the printer becomes ready .
8. If a continuous form is present in the forms path, press Tear, tear off at output
and park the form.
9. Press Path until the indicators for Manual Sheet Feed and the desired
continuous forms path light.
Sequence
This parameter defines the automatic loading sequence. When forms are depleted
from the primary forms path, the printer automatically loads forms from the alternate
path.
None (default)
Defines the automatic loading sequence as disabled.
This setting is used when the printer is set for dual push, but has
different forms loaded in the front push and rear push paths.
FR+RR Defines automatic forms loading from the Front Push forms path
and then the Rear Push forms path.
This setting is used when the printer is set for dual push with the
same forms loaded in the front push and rear push paths.
ASF1+2 Defines the automatic forms loading sequence for the ASF from
tray 1 and then tray 2.
ASF123 Defines the automatic forms loading sequence for the ASF from
tray 1, tray 2, then tray 3.
To change or check the Sequence value:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP
displays.
3. After start-up is complete, release Menu/Enter and the message
PRINT OUT=NO
displays.
4. Press
↓
until the message
FUNCTIONS
displays.
5. Press
→
until the message
FRONT TEAR=xxxx
displays, where xxxx can be
NORM
,
AUTO
, or
NO
.
Chapter 4. Configuring Your Printer
101