©Copyright Lotronic 2013
3
Loop
Address
Binary
Dipswitches
1
1
100000000
＃
1
2
13
101100000
＃
1 + #3+#4
3
25
100110000
＃
1 + #4+#5
N
(N-1)*12+1
The dipswitches setting for DMX address see the " DMX Address
Quick Reference Chart ".
DMX Control Parameter Chart
Channel No
DMX512 fig.
Content
Channel 1
Control
mode
0~49
Sound control
50~99
Auto- beam
100-149
Auto-animation
150~255
manual
Channel 2
Color select
0
Laser off
1-255
Green, red, blue, yellow,
cyan, pink, white
Channel 3
Pattern
select
0-255
patterns
Channel 4
Vertical
move
0-127
Manual
128-191
From down to up speedy
192-255
From up to down speedy
Channel 5
Horizontal
move
1~127
Manual
128-191
From right to left move
192-255
From left to right move
Channel 6
Vertical
rotate
0-255
From slow to speedy
Channel 7
Horizontal
rotate
0-255
From slow to speedy
Channel 8
rotate
0-127
manual
128-191
Anticlockwise rotate
192-255
Clockwise rotate
Channel 9
zoom
0
static
1-85
From small to big
86-170
From big to small
171-255
Auto zoom
Channel
10
Pattern size
0
normal size
1-255
Small to big
Channel
11
Spot and line
0-255
Line to spot
Channel
12
Twinkle
speed
0-22
Slow to speedy
PC Control
If it is set to ILDA mode (use PC software to control light), you just need to
connect the ILDA signal to the DB25 jack. ILDA mode (PC control) and
built-in program mode can be identified and transformed automatically.
Troubleshooting
1. If the power supply indicator doesn't light up and the laser doesn't work,
please check the power supply and the input voltage.
2. In Stand-Alone operation, if the power supply indicator is light up and
sound active indicator isn't light up, but the laser is shut off doesn't work.
A. Because sound is too small make for laser shut off in sound active,
please increase the music volume or increase audio sensitivity with
sensitivity knob, please check as below.
B. Please check if unit has been set up in slave mode, then set up in
master mode.
3. In Master-Slave operation, slave unit don't function, please check as
below.
A. Make sure to there's only one master in the chain, and the others
are set in slave mode.
B.Make sure to take a good quality power cable and connection.
4. In DMX mode operation, the laser is OFF and the DMX signal indicator
is unlighted, please check as below.
A. Make sure to set up the DMX mode.
B. Make sure to have a good connection.
5. In DMX operation, the unit can’t be controlled by the DMX console, but
the DMX signal indicator is flashing, please make sure the DMX console
and unit have the same channel.
6. If the output beam direction above isn't the right way, please restart the
unit.
7. If the unit is fail, please turn off the unit, then turn on again after 5
minutes.
8. In PC mode operation, the laser is OFF after the swimming fish, please
check as below
A. Please press the button of animation
B. Make sure the SD card is insert with good connection
After trying the above solution you still have a problem, please
contact your dealer or our company for service.
