©Copyright Lotronic 2013
2
Always replace with the exact same type fuse, replacement with
anything other than the specified fuse can cause fire or electric shock
and damage your unit, and will void your manufactures warranty.
Function setting
Use the dipswitches to assign the unit’s function: DMX/slave, sound
active or AUTO mode.
For DMX mode, set the DMX address. Each
dipswitch represents a binary value.
See the “Function chart”.
0=OFF 1=ON X=OFF or ON
DIPSWITCH CHART
FUNCTION
#1 #2 #3 #4 #5 #6 #7 #8 #9 #10
0
X
X
X
X
X
X
X
X
0
SOUND ACTIVE
1
X
X
X
X
X
X
X
X
0
AUTO -beam
1
1
X
X
X
X
X
X
X
0
AUTO-animation
X
X
1
X
X
X
X
X
X
0
Slave for Sound
and Auto
1
SET DMX ADDRESS FOR DMX
MODE
1
DMX
Sound Active
The change of the laser pattern is controlled by sound. That means the
rhythm of the sound controls the change of the laser pattern. Turn the
sensitivity knob in the clockwise direction to increase the fixture’s
sensitivity to sound, turn the knob in the counterclockwise direction to
decrease.
AUTO
Auto cycles the built-in programs without being controlled externally.
DMX Control
The system only accepts the DMX512 signal of international standard to
control the system mode, the laser pattern ON /OFF, the size, the position,
the speed, etc.
Master-Slave Operation
This mode will allow you to link up to 32 units together without controller.
1. Install the units in a suitable position (laying or appending).
2. Choose a unit to function as Master mode, set dipswitch to select
Sound Active or AUTO mode. The others must be set to Slave mode, set
dipswitch to select Slave mode.
Slave units set #3 on
3. Use standard XLR microphone cable chain your units together via the
XLR connector on the rear of the units. For longer cable runs we suggest
a terminator at the last fixture.
4. Turn on the all units' power, the units begin to reset, then the units
begin working. The slave units will react the same as the master unit.
5. The units will react to the low frequencies of music via the internal
microphone. Adjust the audio sensitivity knob on the back of the master
unit to make the unit more or less sensitive in sound active. The panel
has LED indicating for sound active.
DMX512
1. Install the units in a suitable position (laying or appending).
2. Use standard XLR microphone cable chain your units together via the
XLR connector on the rear of the units. For longer cable runs we suggest
a terminator at the last fixture.
3. Assign a DMX address to each the unit using dipswitches; see the
"DMX Address Quick Reference Char». (All units set to #1 and #10 on will
be OK)
4. Turn on all units' power, the units begins reset, then the unit begins
working.
5. Use DMX console to control your units.
DMX address calculation
For DMX mode, DMX512 address from #1 to 9# dipswitches must be set,
the address is set from 1 to 511. Each dipswitch represents a binary
value.
No.
Digital No.
No.
Digital No.
1st
1
6th
32
2nd
2
7th
64
3rd
4
8th
128
4th
8
9th
256
5th
16
10th
Set to 0
One unit has 12 channels, so each unit must be assigns 12 channels
at least
