13
Version 20.01, 20-July-2020
Load-bearing reserve
In order to apply the additional loads from the PV system onto the roof, the load-bearing capacity of the
roof and the insolation must be assured by a static expert before planning the installation of the
photovoltaic system.
The surface pressure of the AeroFix base rail G2 Eco is higher than that of the AeroFix base rail G2
because of the smaller contact surface.
Important information:
The assembly system including the modules will load 7 kg/m² (11 kg/m²) to the surface of the roof.
Any additional ballast required to secure the system must also be taken into consideration in accordance
with static calculations. On average, loadings of approx. 5-10 kg/m² are to be expected.
Fig. 10 AeroFlat thermal separation
Summary of Contents for AeroFix 10-EW
