____________________________________________________________________________
__________________________________________________________________________________________________________
Ibath è un marchio Trem srl
Via delle Crede, 10/F - 33170 Pordenone (PN)
–
Italia
Tel. +39 0434 610 782 E-mail
C.F. e P.I. 01280430933
•
Touch the T5 button if you wish to have the maximum surface temperature for a limited time (2 hours), the L5 and L7
LEDs will light up. The radiator will operate at maximum temperature for 2 hours, after which, it will go back to operate
in the function set before the Boost function.
•
If after the settings you wish to lock the keypad, press the T6 button for 5 seconds - you will hear 4 beeps confirming
the setting. When touching the other buttons lightly, the L6 LED will flash for 2-3 seconds indicating the keypad is
currently locked.
6.
Remote control
The IBATH radiators are equipped with infrared remote control, allowing to communicate room temperature control to
the S1 sensor and to set different operating programs.
When the S1 sensor receives the information the L8 LED flashes to indicate the reception of communication, it will then
stay lit to indicate that the device has been programmed.
For good communication, point the remote control towards the receiver unit of the appliance.
The distance between remote control and receiver must not exceed 7 m.
Inserting and replacing batteries
Remove the lid situated at the rear of the remote control.
Insert two 1.5 V - AAA alkaline batteries in the right position paying attention to + and
–
polarity.
Place the lid back into position.
Both in case of replacement of the batteries and of disposal of the remote control, batteries must be removed and
disposed of in compliance with applicable laws, as they are harmful for the environment.
General Description
Double infrared communication, one at the top and one at the bottom of the remote control
Seven push-buttons
Maximum communication distance from device: 7 m
Two -AAA - LR03 - 1.5 V batteries
