background image

 

____________________________________________________________________________ 

  __________________________________________________________________________________________________________ 

Ibath è un marchio Trem srl                                                                                                                                                                                                                                                                                                        

Via delle Crede, 10/F - 33170 Pordenone (PN) 

 Italia                                                                                                                                                                                                                                                             

Tel. +39 0434 610 782 E-mail 

[email protected]

                                                                                                                                                                                                                                                                            

C.F. e P.I. 01280430933 

 

INSTALLATION 

Unpack the appliance and place it either on the polystyrene protection or on a carpet 

 

 

 

Read these instructions carefully before installing 
and using the appliance. Keep them for all future 
reference. 

 

Use the appliance only according to these 
instructions. 

 

These instructions, however, do not cover all 
situations that may arise. Use caution and common 
sense when installing and using the appliance. 

 

It is forbidden to modify in any way the features of 

the appliance or to disconnect fixed parts

.

 

 

Make sure that the appliance is in good state. 

 

Do not use the appliance if damaged.                                                  
Contact the retailer or professional qualified 
personnel. 

 

The materials used for packaging can be recycled. 
For disposal use the dedicated recycling containers

 

 

1.

 

Positioning and installation 

 

This appliance is intended for domestic use for room heating. It shall not be used for other purposes. 
It must be fixed onto a wall as indicated in this instruction manual. 
In case of vertical positioning the control graphics must be kept on the right-hand side, while for horizontal 
positioning the control graphics must be kept on the lower side. 
In the bathroom or shower the appliance must be fitted outside the safety zone. 
The control devices must be out of reach for people in the bathroom or shower. 
The controls must be placed in zone 3 (Fig.1) 

 

 

Keep the given minimum distances. (Fig 2-3) 

 
 

 
 
 
 
 

 
 

 

 

 

 

Summary of Contents for ALFA













Reviews: