11
Rev. 171109
i3-TRNG-CAMS-Ax47R_67R-UM.indd
4.5 Mounting w/ Ax61BB Back Box (optional)
The Ax61BB is an optional extension back box for cable management and surface
mounting. Ax61BB back box is also needed for pendant or horizontal wall mount
installations (additional mounting accessories required). Ax61BB back box is compatible
with i3’s optional DB60 (Goose Neck Wall Bracket). EMT 3/4” Pipe can be used in
combination with Ax61BB for pendant mounting.
Pendant Mount
EMT Pipe 3/4”
(Optional)
Ax61BB
Back Box
(Optional)
DB60 Goose Neck
Wall Bracket
(Optional)
Add Sealant
Alignment
marks
Align holes
Ax47R/67R
Camera
Ax47R/67R
Lexan dome
bubble
1. Install the Ax61BB for surface
mount, pendant mount, or Horizontal
wall mount as required.
2. When installing, position the 1/2”
thread to the rear or, when surface
mounting indoor - to the top. When
installing outdoors, position thread
downwards to aid in weather-
proofing.
3. If surface mounting, note that the
Ax61BB back box has 6 (six) 90%
pre-drilled hole locations. Complete
drilling of at least two of these holes
for a secure installation.
4. Place the connector in line with the
center wall and rotate the retaining
clip to prevent the connector from
dropping out. This will aid when
rotating the camera base housing
to guide the cable and find the
mounting holes.
5. Mounting holes for the Ax47R/67R
cameras are identified with a
triangle on the lip of the Ax61BB
back box.
6.
U
se the provided security Torx key
to loosen three screws securing
the Lexan (Dome) Bubble housing
to the camera’s mounting base. Do
not completely remove the screws
from the dome bubble. Lift the dome
bubble off and set aside.
Always add silicon to the threads
and use screws with the ‘O’ ring
(not supplied) to maintain the
IP67 rating.
