31
This section will allow you setup the parameters for individual IP camera for I-View’s and the
other brand.
Disable channel:
This will disable the selected channel when enable this function.
Install video codec:
Install the video codec of this IP camera when you connect IP camera at
first time, if the IP camera cannot display the video on the screen.
Vendor & Model:
Select the correct brand and model for the connected IP camera. You also
can select “Onvif
”
if your IP camera support Onvif compliant and not on the list. You can
check the used camera support Onvif compliant from: http://www.onvif.org. Click “
Onvif
setup
“ icon to setup the parameters or entry RTSP command code directly which you want to
run on the Hybrid DVR or NVR.
Compress:
Select the suitable codec for video recording and transmission.
Recording resolution:
Select the resolution for video recording and display.
Frame rate:
Select the frame rate for video recording and display
.
Rate Control:
You can choice video quality or bit rate from this tab. Good video quality or
large bit rate request bigger storage capability.
IP address:
Entry the correct IP address for the connected IP camera. If you do not know the IP
camera’
s IP address, you can cli
ck “
Find
”
icon to find out the currently connected IP cameras
User name & Password:
The user name and password must be matched the setting of IP
camera which you want to connect.
Find:
Click this icon to find out all the currently connected IP cameras on the list. Click the IP
camera and find out the information of each IP camera. Please refer the diagram shown as
above
Fig D.
Click the IP address and “
Select
”
icon, the network
information of this IP
camera will be added for this channel. The Fig D diagram please refers to “
1. Setup the
parameters of All IP cameras (For I-View’s IP camera only)”
Section
Advance setup:
Click this icon will enable the detail parameters setting of IP camera. You need
to load the Active X if this NVR is activated this process at first time.
The difference IP camera brand has its own “
Find
”
and “
Advance setup
”
setup diagram and
setting process. For the detail information
,
please refer to the IP camera operation menu.
HTTP port & RTSP port:
The both port number must be matched the setting of IP camera
