IACER Srl
68
MNPG178
M16/M17/M18 • Agonist/antagonist (non-medical programs)
Cable type: TYPE 1 (see Figure 1 - Cable type.)
Available programs to set treatments with alternated contractions on a
pair of channels.
Electrodes’ positioning: to refer to the photos of the
Position manual
.
−
To move the cursor and select the stimulation parameter, use the
right and left arrow keys, change the values with the up and down
arrow keys.
−
Once all the stimulation parameters have been set, position the
cursor on "OK" to memorize the program.
−
To start the stored program, press the OK button.
−
The end of the program is signaled with a triple acoustic signal.
Table of settable values:
Parameter description
Minimum
Maximum
Contraction frequency
20 Hertz
120 Hertz
Contraction period
2 seconds
10 seconds
Recovery frequency
0 Hertz
12 Hertz
Recovery period
2 seconds
26 seconds
Impulse width
60 microseconds
500 microseconds
Program total time
1 minute
60 minutes
C01 • Controlled stimulation (non-medical program).
Cable type: TYPE 1 (see Figure 1 - Cable type.) active channels: CH1
This program can be used when there is a need to research the muscle's
innervation point very precisely. It is used exclusively by connecting a tip
(finder pen) to the red 2mm plug and positioning a pregelled electrode on
the muscle belly: by activating stimulation and moving the tip near the
muscle innervation point it is possible to have an immediate visual
perception of the point of maximum contraction muscle.
