44
7.4
The disc brushes
7.4.1
Removing the disc brushes
ATTENTION
The supporting bolts are fixed for transportation, please check them and loosen them if
they are fixed.
1.
Make sure that the ignition key is in position
"0" and remove it. Keep it with you during
maintenance.
2.
Lift the grey brush cover a little.
3.
Pull it from its supporting bolts
(Figure 40, pos 1) to remove it.
4.
Carefully place it on the floor or a level
surface.
Figure 40
5.
Push the two springs (Figure 41, pos 1) fully
outward until they lock into place, behind
the cams. The clamp is now released.
6.
Carefully remove the disc brush
(Figure 41, pos 2).
7.
Place it on the floor or on a level surface.
5.
Repeat this sequence for the second disc
brush.
Figure 41
