6
Introduction
(continued)
Clear a space when placing this recorder.
When stacking multiple recorders, clear a space of more
than 5 cm {2 inches} from both sides, the top, the bottom
and the rear of the recorders.
More than
5 cm {2 inches}
More than
5 cm {2 inches}
More than
5 cm {2 inches}
More than
5 cm {2 inches}
• Do not stack this product in a stack.
• Do not place anything that can generate vibration on the
top of this product.
Heat dissipation
To prevent this product from overheating, heed the
following. Failure to observe this may cause fire or trouble.
• Do not block the cooling fan outlet or the ventilation holes
with a wall, rack, cloth, etc. Maintain the product
periodically to prevent dust from blocking ventilation
holes.
• The lifetime of the cooling fan is limited by use. It is
recommended to replace them after around 30000
hours of operation. Contact your dealer for replacement
of the cooling fans.
• When the internal temperature rises, the fan noise may
become louder.
• Clear a space of more than 5 cm {2 inches} from both
sides, the top, and the rear of the product. Do not block
the ventilation holes on the front side since this product
is designed to cool the hard disk drives by drawing in air
from the front.
Avoid placing this product near noise sources
If the cables are placed near noise sources such as
fluorescent lamps, noises may be produced. In this case,
rewire avoiding the noise sources, or move the product to a
place far from the source.
Grounding
Confirm that the wire is connected from the SIGNAL GND
terminal to earth ground.
A grounding connection must be made before connecting
the power plug or this product to the main power supply.
When disconnecting the grounding wire, make sure that the
power plug of this product is disconnected from the main
power supply.
Avoid placing receptacles that contain liquids such as
water near this product.
If liquid spills onto this product, it may cause fire or an
electric shock.
Shielded (STP) LAN cables must be used with this unit
to ensure compliance with EMC standards. (Excluding
U.S.A. and Canada)
About sulfuration of rubber products
Do not leave rubber products containing sulfur (packing and
rubber feet) close to the recorder or in the same storing box.
Sulfur constituent from the rubber products may cause
sulfuration corrosion on electrical parts or terminals and
defects in the recorder.
Equipment classification and power source indication
label
Refer to the indication label on the bottom side of this unit
for the equipment classification, power source, and other
information.
