Hyundai HDF 50-7S, Service Manual

Page: 274 / 518

6-27
Position valve assembly with the mounting
pads of the end sections on a flat surface.
To obtain proper alignment of end sections
relative to the spool sections apply
downward pressure to the end sections ;
Snug tie rod nuts to about 10lbf ft.
Final torque the two 11/16 nuts to 48
5lbf ft ; Final torque the 3/4 nut to 74
8lbf ft. Check for proper spool movement.
5)
Install auxiliary valves and plugs and torque
to proper specifications.
General assembly notes:
A. Lever assemblies can be installed on
section before or after complete valve
assembly.
B. The load check and spring may be
omitter from assembly in certain circuit
conditions(i.e., motor spools). 6)
7406S MCV06(1)
7406S MCV06(2)
https://www.forkliftpdfmanuals.com/