Hyundai EQUUS 2016, Owner'S Manual

Page: 151 / 477

Rolling code programming
Rolling code devices, which are
"code-protected" and manufactured
after 1996, may be determined by
the followings:
• Reference in the device manual
for verification.
• The handheld transmitter appears
to program the HomeLink
®
Universal Transceiver but does not
activate the device.
• Press and hold the trained
HomeLink ® button. The device has
the rolling code function if the indi-
cator light flashes rapidly and then
turns constantly ON after 2 sec-
onds.
To train rolling code devices, follow
these instructions:
1. At the garage door opener receiv-
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
Exact location and color of the but-
ton may vary by garage door
opener brand. If there is difficulty
locating the training button, refer-
ence the device owner's manual or
please visit our Web site at
www.homelink.com.
2. Firmly press and release the
"learn" or "smart" button (which
activates the "training light").
Information
Wait for 30 seconds before starting the
step 3.
3. Return to the vehicle. Firmly press
and hold the desired HomeLink ®
button for two seconds. Then,
release it.
Repeat the
"press/hold/release" sequence a
second time to complete the pro-
gramming. (Some devices may
require you to repeat this
sequence a third time to complete
the programming.)
4. Press and hold the just-trained
HomeLink
®
button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate.
5. To program the remaining two
HomeLink ® buttons, follow either
the steps 1 to 4, as above, for other
Rolling Code devices or the steps
2 to 5 in Standard Programming for
standard devices.
Gate operator & Canadian
programming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink
® Wireless
Control System button (refer to the
steps 2 to 4 in the Standard
Programming) while you press and
re-press ("cycle") your handheld
transmitter every two seconds until
the frequency signal is learned. The
indicator light will flash slowly and
then rapidly after several seconds
upon successful training.
i
3-56
Convenient features of your vehicle