Hyundai EQUUS 2016, Owner'S Manual

Page: 152 / 477

Operating HomeLink
®
To operate, simply press and release
the programmed HomeLink
® button.
Activation will occur for the trained
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For
convenience, the hand-held transmit-
ter of the device may also be used at
any time.
Reprogramming a single
HomeLink
®
button
To program a new device to a previ-
ously trained HomeLink
® button, fol-
low these steps:
1. Press and hold the desired
HomeLink
®
button. Do NOT release
until the step 4 is completed.
2. When the indicator light begins to
flash slowly (after 20 seconds),
point the handheld transmitter 1 to
3 inches away from the
HomeLink
® surface.
3. Press and hold the handheld
transmitter button. The HomeLink ®
indicator light will flash, first slowly
and then rapidly.
4. When the indicator light begins to
flash rapidly, release both buttons.
5. Press and hold the just-trained
HomeLink ® button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
Erasing HomeLink
®
buttons
An individual programming cannot
be erased. However, to erase all
three programmings;
1. Press and hold the two outer
HomeLink ® buttons until the indi-
cator light begins to flash after 20
seconds; and
2. Release both buttons. Do not hold
for longer than 30 seconds.
The Integrated HomeLink ® Wireless
Control System is now in the training
(learning) mode and can be pro-
grammed at any time by following the
appropriate steps as in the
"Programming".
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
3-57
Convenient features of your vehicle
03