Hyundai EQUUS 2016, Owner'S Manual

Page: 144 / 477

3. Simultaneously press and hold
both the HomeLink ® and handheld
transmitter buttons until the
HomeLink
® indicator changes
from slow flashing to rapid flash-
ing. Now you may release both the
HomeLink
® and hand-held trans-
mitter buttons.
Information
Some devices may require you to
replace this Programming step 3 with
procedures noted in the "Gate
Operator/Canadian Programming"
chapter. When the HomeLink
® indica-
tor does not change to rapid flashing
after performing these steps, contact
HomeLink
®
at www.homelink.com.
4. Firmly press, hold for 5 seconds
and release the programmed
HomeLink
® button up to two sep-
arate times to activate the door.
When the door does not activate,
press and hold the just-pro-
grammed HomeLink
® button and
observe the indicator.
• When the indicator remains illu-
minated, programming is com-
plete. Your device will activate by
pressing and releasing the
HomeLink
® button.
• When the indicator flashes rapid-
ly for 2 seconds and then turns to
a constant light, continue with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code-equipped device (most
commonly a garage door open-
er).
5. At the garage door opener receiv-
er (motor-head unit) in the
garage, find the "learn" or "smart"
button. This can usually be found
where the hanging antenna wire
is attached to the motor-head
unit.
6. Firmly press and release the
"learn" or "smart" button. (The
name and color of the button vary
by manufacturer). Wait for 30 sec-
onds before starting the step 7.
7. Return to the vehicle. Firmly
press and hold the programmed
HomeLink
® button for 2 seconds.
Then release it. Repeat this
"press/hold/release" sequence
for the second time. Depending
on the brand of the garage door
opener (or other rolling code
equipped device), repeat this
sequence for the third time to
complete the programming
process.
HomeLink ® should now activate your
rolling code equipped device.
i
3-49
Convenient features of your vehicle
03