Hyundai EQUUS 2016, Owner'S Manual

Page: 335 / 477

Hazard warning flasher
The hazard warning flasher serves
as a warning to other drivers to be
extremely cautious when approach-
ing, passing by or passing ahead.
It should be used when your vehicle
is under emergency repair, or when
your vehicle stops on the edge of a
roadway.
Press the flasher switch regardless
of the ignition switch position. The
flasher switch is on the switch panel
of the center consol. All turn signal
lights will simultaneously flash.
• The hazard warning flasher oper-
ates, whether your vehicle is run-
ning or not.
• The turn signals cannot be turned
ON when the hazard flasher is ON.
• Care must be taken to turn ON the
hazard warning flasher, when tow-
ing your vehicle.
If the engine stalls at a cross-
road or a railroad crossing
If the engine stalls at a crossroad or
a railroad crossing, set the shift lever
in N(Neutral) and then push the
vehicle to a safe place.
If you have a flat tire while
driving
If a tire goes flat while driving:
1.Take your foot off the accelerator
and slow down the speed while
driving straight ahead. Do not
abruptly apply the brakes in an
attempt to pull over the vehicle, as
this may cause a loss of control.
When the driving speed gets suffi-
ciently lowered to stop the vehicle,
carefully apply the brake and pull
off the road. Drive away from the
road as far as possible and safely
park the vehicle in a safe and flat
place. When you are on a divided
highway, do not park the vehicle in
the median area between the two
directions.
2.When the vehicle is stopped, turn
ON the emergency hazard flasher,
set the parking brake, and set the
shift lever in P(Park).
3.Have all occupants get out of the
vehicle. Make sure they stay out of
the roadway.
4.When changing a flat tire, follow
the instruction provided in the fol-
lowing part of this chapter.
R RO OA AD D W WA AR RN NIIN NG G
6-2
What to do in an emergency
OVI045086N
IIN N C CA AS SE E O OF F A AN N E EM ME ER RG GE EN NC CY Y
W WH HIIL LE E D DR RIIV VIIN NG G