Operation
35
Operation
34
Operation
Operation
7.2
Setup
c. Edit(Press YELLOW)
You can search channels from selected TP and you can edit transponder’s settings.
I. Transponder
: This is the name of the transponder. Press
button to change the
name.
II. Frequency
: Enter the frequency by using the numerical button.
III. Symbol Rate
: Enter the symbol rate by using the numerical button.
IV. Polarity
: Press /
buttons to switch the signal polarity (horizontal or vertical).
V. Modulation
: Press /
buttons to switch among DVB-S, DVB-S2/QPSK, DVB-S2/8PSK.
When you select the DVB-S2, you can set FEC or Pilot.
- Scan
: Press
“GREEN”
button to go to the scan menu.
Please refer to
7.2.4 SATELLITE
ƍ
1. LNB
ƍ ڹ
EDIT SATELLITE
ƍ
a.Scan
- Return :
Press
“MENU”
button to go to the previous menu.
ҫ
Note : When you select DVB-S2, you must enter the FEC correctly
ҫ
Note :
If the scanning process fails, please check whether your entered values are
correct or signal reception is good or bad.
ҫ
Note :
The Frequency, Symbol Rate, Polarity, Modulation(FEC, Pilot) mentioned above
are very important for optimal satellite signal reception. We recommend you to
get professional advice available.
D. Delete (Press BLUE)
You can delete a transponder. If you enter the password correctly, the transponder will
be deleted.
E. New TP (Press ORANGE)
You can add a new transponder. Press “ORANGE” button, Edit window will pop up. After
you put transponder information, press “RED” button to save it.
VOL
VOL
VOL
VOL
7.2
Setup
5. SYSTEM
1) TIME ADJUST
MENU > SETUP > SYSTEM > TIME ADJUST
You can change the settings for the time.
͈
SET
: You can see the current time.
͉
Reference Program
: You can set the receiver’s time to particular channel by pressing
The time on your receiver depends on the channel’s time if
you set this option.
͊
GMT OFFSET
: You can press /
buttons to switch
“GMT Offset”
value. The range is
“
-
12:00 ~ +12:00”
, increase each half hour progressively.
͋
DAYLIGHT SAVING
: You can adjust daylight saving time when summer time is
applicable by pressing
ҫ
Note : It is very important that you have to set reference program. local time base on
reference program.
Whenever you turn the AC power off/on, system received the time information
from reference program.
VOL
VOL
