Hyundai 20G-7, Service Manual

Page: 275 / 420

1-4
GENERAL
TIGHTENING TORQUE TABLE OF STANDARD PARTS
NOTE
•
The torques shown in the table are standard val-
ues under the following conditions.
1. Nuts and bolt are made of steel bar and
galvanized.
2. Galvanized plain steel washers are inserted.
3. All nuts, bolts, plain washers are dry.
• The torques shown in the table are not applicable,
1. When spring washers, toothed washers and
the like are inserted.
2. If plastic parts are fastened.
3. If oil is applied to threads and surfaces.
• If you reduce the torques in the table to the per-
centage indicated below under the following
conditions, it will be the standard value.
1. If spring washers are used : 85%
2. If threads and bearing surfaces are stained
with oil: 85%
Head mark 7
0.5 ~ 0.6
0.9 ~ 1.1
2.0 ~ 2.5
4.0 ~ 5.0
6 ~ 8
12 ~ 14
18 ~ 21
26 ~ 30
36 ~ 42
48 ~ 55
61 ~ 70
Head mark 4
Bolt nominal diameter
(mm)
0.3 ~ 0.4
0.5 ~ 0.6
1.2 ~ 1.5
2.5 ~ 3.0
3.5 ~ 4.5
7.5 ~ 8.5
11 ~ 13
16 ~ 18
22 ~ 25
29 ~ 33
37 ~ 42
0.8
1.0
1.25
1.25
1.25
1.2
1.5
1.5
1.5
1.5
1.5
M5
M6
M8
M10
M12
M14
M16
M18
M20
M22
M24
Torque (kg
·
m)
Pitch
(mm)
L4GC205A L4GC206A L4GC207A L4GC208A