HYT TR-800, Service Manual

Page: 19 / 90

TR-800 Service Manual
17
arrow in “Horn Alert Logic Signal” and select “1s” if you are using REPEATER STUN FUNCTION.
The horn relay contact at the accessory connector of the receiver will close to inform the
μ P to toggle
between the SETUP and KNOCKDOWN status once the receiver successfully decodes a signaling
such as 5-Tone sequence. Your screen will be shown in Figure 6-8.
Figure 6-8
41. Close the “Miscellaneous” window.
42. Double click on the “Per Personality - 1” option from the treeview menu of “Per Personality”.
43. There is only one personality setting for factory default configuration. Click the “
+
” button to add
personality settings or “
×
” button to delete them. Not all the personality settings should be
programmed into the repeater. The personality settings are intended to record and save different
groups of personalized data, and for successive assignment in “Per Channel” configuration.
44. Select the “Squelch” tab.
45. Select the “RX Squelch Mode” based upon the squelch type that the repeater will use. Select
“CTCSS/CDCSS” if the repeater uses subtone signaling. See screen be shown in Figure 6-9.