Hypertherm ArcGlide Torch Height Control, Instruction Manual

Page: 164 / 208

4-34 ArcGlide THC Instruction Manual
MAINteNANCe
error Description Possible Causes Corrective action
23
The AC input voltage
to the control module
exceeds the low tolerance
limit.
The control module is
configured for 220 VAC
and 120 VAC is being
applied.
There is a problem with
the incoming voltage to the
control module.
Verify that the control module is configured for the line
voltage being applied.
Check the incoming voltage to the control module.
24
The AC Input voltage
to the control module
exceeds the high tolerance
limit.
The control module is
configured for 120 VAC
and 220 VAC is being
applied.
Verify that the control module is configured for the line
voltage being applied.
Check the incoming voltage to the control module.
25
The processor temperature
within the control
module has exceeded its
recommended operating
temperature.
Allow the control module
to cool down to within
the normal operating
temperature before
continuing operating the
ArcGlide.
The ambient temperature
has exceeded the specified
maximum temperature for
the control module.
The control module is
located inside a cabinet
and the air in the cabinet is
not properly circulated or
the fans inside the cabinet
are not functioning.
The control module is
mounted too close to other
heat dissipating devices or
components.
Internal failure with the
control module.
Verify that the ambient temperature does not
exceed the manufacturer’s recommended operating
temperature.
If the control module is mounted within a cabinet,
check the ambient temperate within the cabinet and
verify that air is continuously being circulating inside
the cabinet.
If fans or coolers are present, verify that these
components are functioning by design.
Verify that other heat dissipating components are not
mounted too close to the control module.
If this error occurs repeatedly, contact Hypertherm
Technical Service.
2