hymer BMC 550, Instruction Manual

Page: 160 / 252

9 Appliances
160
B-MC - 12/18-2 - EHG-0016-01EN

Press the light button (Fig. 176,5) and keep it pressed until the desired
brightness is reached.

Press the light button (Fig. 176,5).

The Setup button (Fig. 176,4) is used to connect the remote control with
the air conditioning unit during first set-up.

Further information can be obtained in the manufacturer's instruction
manual.
9.4 Controlling Truma appliances with mobile terminal
(special equipment)
Depending on the equipment, a Truma iNet-Box is installed in the vehicle.
With the Truma iNet-Box, the heater and the air conditioning unit can be op-
erated from a mobile terminal (e.g. smartphone, tablet PC) via an app. The
Truma app can be downloaded for common mobile terminals from the re-
spective app stores.
There are two possibilities for the communication between the Truma appli-
ance and the mobile terminal:

Bluetooth connection (limited range)

Connection via the mobile communication network (a mini SIM card with
own telephone number and sufficient credit is required; not included in
the scope of delivery). Operating is carried out via SMS.
The operation of the Truma appliances is possible from multiple mobile ter-
minals. In order to do this, the Truma app must be installed on each mobile
terminal.

When the mobile terminal has an Internet connection, the instructions for
operating the Truma appliances are downloaded and stored. The in-
structions will then be available at any time (even without Internet con-
nection).
1 BLUETOOTH button
2 Slot for mini SIM card
3 Antenna connection for external
GSM antenna
4 External/internal GSM antenna
change-over switch
5 GSM LED, red (lit when GSM oper-
ation is not possible)
6 POWER LED, green (lit when oper-
ating)
7 BLUETOOTH LED, blue (flashes
during pairing)
Fig. 177 Truma iNet-Box

Install Truma app on the mobile terminal.

Switch on the 12 V power supply of the vehicle on the panel.

Switch on Bluetooth on the mobile terminal.

Start Truma app and select the menu items "SETTINGS – Setup Truma
iNet-Box – Configure Bluetooth". The individual steps are described in
detail in the Truma app.
Dimming the lighting:
Switching off the lighting:
Setting up the Bluetooth
connection: