hymer BMC 550, Instruction Manual

Page: 155 / 252

Appliances 9
B-MC - 12/18-2 - EHG-0016-01EN
155

Set the lever (Fig. 170,1) parallel to the pipe.
Vehicles with gas bottle compartment
behind the rear axle: The spherical
valve is installed in the storage box behind the driver's seat. It is accessible
via a storage space flap.
Vehicles with gas bottle compartment
in front of the rear axle: The spherical
valve is installed in floor compartment underneath the table. It is accessible
from the inside via a floor lid.
9.2.4 Rear garage hot-water heater

Never drill holes in the floor. This might damage the hot-water pipes.

The rear garage can only be heated if the hot-water heater is running.

The heat output depends on the temperature of the heating liquid in the
hot-water heating system.

Only the distribution of the hot water for heating is adjusted with the inlet
valves. The temperature and thereby the power of the heating itself is
set at the operating unit.
Fig. 171 Inlet valves (rear garage hea-
ting)

Adjust the handle (Fig. 171,1) on the inlet valve for the rear garage heat-
ing so that it is parallel to the heating pipe. The rear garage heating is
now working at maximum power.

Set the handle (Fig. 171,1) on the inlet valve for the rear garage heating
to the desired position. This enables the hot water distribution to the rear
garage to be continuously adjusted.

Set the handle (Fig. 171,1) on the inlet valve for the rear garage heating
so that it is horizontal to the heating pipe. The rear garage heating is
now switched off.
Opening the spherical
valve:
Position of spherical
valve
Switching on the rear
garage heating:
Adjusting heat output:
Switching off the rear
garage heating: