Page 51
r16 Service
_message_unit
.
Code
Denominat.
Explanation
0
No_service
_msg
A service is not required.
2
Cycles_main
_contactor 1
The maximum number of operating cycles for K1
has been reached and a Service_main_contactor is
required.
17
Operating
_time
A service is required due to the number of operating
hours.
15
Water_inlet
_pressure
_min.
The water inlet pressure is below the specified mini-
mum value. The vane pump operation is on hold
until the pressure has maintained the minimum
value for a defined period. The occurrence of the
service message is recorded in an internal counter.
If the service message has occurred 5 times, the
fault message Pressure_water input is raised. The
internal counter is counted down by 1 each time
when the water input pressure has not fallen below
the minimum value for a contigous period of 10 min-
utes.
16
Nozzles
The nozzle condition of the spraying system
requires maintenance.
18
Control
The control of the humidifier should be optimized.
20
Water_inlet
_pressure
_max.
The water inlet pressure is beyond the specified
maximum value. The vane pump operation is on
hold until the pressure has fallen under the maxi-
mum value.
r40
Pressure
_actual_value
The actual pressure value (in bar)
r41
Pressure_set
_value
The pressure set value (in bar)
r44
Frequency
_set_value
The frequency set value (in Hz) for driving the pump
motor
r45
Load_actual
The actual number of loads (nozzle segments that
are driven
Set value
Explanatiom
P00 Code level
Allows advanced level access by code input (Code „10“) or limitation
to basic level (Code „00“). Advanced level is exited automatically
after 10 mins without a keystroke.
PAr Parameter selection
Allows selection of parameter group and of a specific parameter
within a group on the advanced level (after code input).
Reading value pointer
Explanation
