HYDROSCAND H120BASIC, User Manual

Page: 12 / 29

Page 12
h120bASIc uSEr mAnuAL EdItIon II 2016-12-28
6. Maintenance
6.1 Lubrication
The machine must be cleaned and lubricated every eight working hours. When lubricating, the dies
should be returned as far as possible, but no more than that you can reach the grease fi ttings. Use a
grease gun that plugs into the nipples. (1). Excess grease should be removed. Lubricate rather less
and often than seldom and a lot. If the machine is not lubricated the machine loses power and the
sliding surfaces inside the machine will be damaged. Use only grease recommended by Hydroscand
machine Ab.
Recommended grease: Optimol viscogen
6.2 Oil and fi lter change
Oil should be changed once a year. When changing oil, the dies should be fully opened. Drain the old
oil by opening the drain plug in the bottom of the tank (1) or use a suction device and suck out the
oil through the oil fi ller cap (2). Change the fi lter every oil change. Then fi ll the new oil to the mark
on sight glass. Unscrew the fi lter housing (2), take out and repalce the fi lter.
Use only oil recommended by Hydroscand Machine AB.
Recommended oil: ISO VG46 or equivalent.
1
2
1