19
Rev. 04082020
1.
After confirming the proper spacing, place the Hull Support Bracket for a Hull Pad to the I
-
Beam. Hold it
in place with an
18”
bar clamp.
2.
Mount the Hull Support Bracket to the I
-
Beam using the U
-
Bolts, Lock Washers, and Brass Nuts.
Drill a
7/16" hole through the Hull Support Bracket to connect the U
-
Bolts to the Cross Channel.
3.
Center the Hull Pad from bow to stern.
4.
When placing the Hull Pad, rest it on the Cross Channel against the Hull support bracket. Secure it with an
18”
bar clamp.
5.
Drill a
7/16”
hole through the Hull Pad under the internal web, and then fasten it to the Hull Support
Bracket using the
4”
bolt, a flat washer, lock washer, and brass nut.
6.
Repeat these steps for the opposite side Hull Pad.
STEP 7(b): MOUNTING THE HULL PADS (V
-
HULL ONLY)
Part #
Parts Required
1035104*
ASSY HYH HARBORHOIST ALUM BUNK
-
12FT.
1035105*
ASSY HYH HARBORHOIST ALUM BUNK
-
16FT
1035106*
ASSY HYH HARBORHOIST ALUM BUNK
-
20FT
Part #
Hardware Required
HH
-
2603
NUT 3/8"
-
16 BRASS
2090242
WASHER
-
FLAT
-
3/8" SS
HH
-
LPL
-
1505
LOCK WASHER 3/8"
-
16 SS
HH
-
LPL
-
1503
U
-
BOLT
-
.375x3x5 SS
Hull Pad*
Full Length Hull
Support Bracket
U
-
Bolt .375 x 3 x 5
Washer
-
FLT
3/8”
Lock Washer
3/8”
Nut
3/8”
-
16
Use Kit Box: 1035195
* See Chart 4 for the Hull Pad used for each model of lift.
Summary of Contents for HarborHoist HH-4400
Page 1: ...1 Rev 04082020 ...
Page 35: ...35 Rev 04082020 Appendix ...
Page 38: ...38 Rev 04022020 ...
