Hydro-Pro 7018522, User And Service Manual

Page: 20 / 193

- 19 -
Water Inlet & outlet junction
1. Use the pipe tape to connect the
water Inlet & outlet junction onto the
heat pump
2. Install the two joints like the
picture shows
3. Screw them onto the water Inlet &
outlet junction
10M Signal wiring
1. Take one side of the 10M Signal
wire, to connect with the controller.
2. The other side needs to be pulled
through the hole, like the third
picture shows.
3. Then connect to the PC board
inside the machine : the brown one
--- first joint; the blue one --- second
joint; the yellow one --- third joint.
Cable wiring
1. Connect the power supply wire
through the white hole like the
picture shows.
2. Fix the other side on joints inside
the electric box.
Water pump wiring
1. Connect the water pump wire
through the white hole marked
2. Fix the other side on joints inside
the electric box.