Hydro International Hydro-Logic Flexi Logger 100, User Manual

Page: 11 / 62

Hydro-Logic
®
Flexi Logger 100
User Manual
6 April 2018 Page 11 of 62
Connecting to Timeview
With the logger switched on, press and hold the dial-out button until you see a
yellow flash on the LED.
The logger will then begin a series of steps to call out to Timeview. Progress can
be followed using the
Status LED flash patterns , or you can just wait for a few
minutes until the red, blue and green flashing has stopped and the logger has
gone back to a
single blue flash every 2s .
Now see Finding your data on Timeview
– you should be able to see that your
logger has connected successfully.
If the mobile data signal is poor, the logger will try several times to transfer data
to Timeview, so there is no need to press the dial-out button more than once.
Recording test data from the sensor
If you have ordered the Pre-wiring and configuration service , the sensor can be
immediately connected to the large SCA connector on the logger body.
If you need to wire your own sensor, see the section Sensors for more
information.
Once the sensor is connected, you should ensure that the clock is reset (either by
Resetting logger clock with Timeview or Resetting the logger clock with Harvest)
This will clean any blank data points that were recorded with no sensor