27
Water Test Kit
Part #01-108305S
The Water Test Kit is used to test the hardness of the water. If the reading is above 180 ppm softening
salts may be required in the Hydrim. To test the water, go to a sink close to the Hydrim. Remove one
of the three test strip packets from the envelope. Open the test packet and remove the test strip. Hold
the yellow end of the test strip under cold running water for approximately three seconds. Compare the
color of the test strip to the color chart on the test strip packet. Compare the ppm reading for this color
to the chart for the Hydrim you are installing. Add softening salt and adjust the salt regeneration as
needed.
Summary of Contents for L110W
Page 1: ...Hydrim L110W Training Manual Training Manual ...
Page 4: ...4 ...
