23: Titan 575 Owner’s Guide
SHUT-DOWN PROCEDURE
1.
Flush clean water through the chemical system for 10 seconds. Turn the “CHEMICAL
SELECTION VALVE” to “OFF.”
2.
Cool the truckmount down by turning the “PUMP CLUTCH” switch to “PUMP ON
- NO HEAT”. Spray the cleaning wand into the vacuum hose for 3-5 minutes. The
chemical should now be flushed from the truckmount, hoses and cleaning tool.
3. Remove the vacuum hose.
4.
Lubricate the blower to prevent it from rusting internally.
a. Allow the unit to run for a few minutes with the vacuum hose disconnected in
order to remove moisture from the blower.
b.
Cap off the inlet(s) to the vacuum tank.
c.
Spray a HydraMaster-recommended spray lubricant into the “BLOWER LUBE
PORT” for about 5 to 10 seconds while the unit is running (see Figure 4-5).
d.
Allow machine to run additional 2 to 5 minutes under load to flush off lubricant.
e. Uncap the inlet(s) and run the unit for another minute to allow the blower to cool
down.
Figure 5. Location of Blower Lube Port
Blower Lube Port
Summary of Contents for Titan 575
Page 2: ......
